What Are The Standard Commands for Repeater Control and Linking?

"NODE" is to be replaced with Allstar NODE number, or "0" to refer to last node specified.

"MACRO" is one of the system macro numbers (at least 1 digit).
0 will execute the system startup MACRO, if any.

*1NODE - Disconnect link to NODE
*2NODE - Connect Monitor-only link to NODE
*3NODE - Connect link to NODE
*4NODE - Enter Command Mode for NODE (see below)
*5MACRO - Execute MACRO specified
*6 - Autopatch Up
*0 - Autopatch Down
*7 - Node List (local)
*80 - Force ID
*81 - Get time of day
*82 - Get software rev.
*87 - Full Node List
*951NODE - Disconnect Permanent link to NODE
*952NODE - Connect Permanent Monitor-only link to NODE
*953NODE - Connect Permanent link to NODE
*954 - All links off (including Permanent ones)
*969032 - System Disable
*969031 - System Enable
*969068 - System Reset
*98 - Telephone PTT (# unkeys)
*99 - Send 1 KHz test tone
*97 - Force (*) thru system
*90 - Force (#) thru system

Command Mode -- When you enter command mode for a node, you are
re-directing your DTMF tones to command the selected node, and to be
ignored by the local system. To exit command mode, hit '#'. You may only command a node that is connected to you, or is down the chain of systems connected to you (is included in the Full Node List, *87).