Touch Tone Commands

A radio with a Touch Tone (DTMF) keypad or the iaxRpt PTT Client can be used to enter these commands.

Usually commands are processed locally by the node controlling the repeater. However you can enter a command to connect to another node in command mode and send it commands. When you enter into command mode for a specific node your DTMF tones are directed to and interpreted by that node. Refer to the list below for the command.

To exit command mode, hit '#'. To send commands to another node it must be connected to your local node either directly or through a chain of connections. To hear a list of connected nodes use the command *87.

In the list below, replace "NODE" with the repeater node number (e.g. 2075), or "0" to refer to last node specified. These commands are the defaults for a node. They may be enabled or disabled by the System Administrator and even assigned different codes. "MACRO" is one of the system macro numbers (at least 1 digit).
Entering "0" will refer to and execute the system startup MACRO, if any.

*1NODE

Disconnect link to NODE

*2NODE

Connect Monitor-only link to NODE

*3NODE

Connect link to NODE in Transceive

*4NODE

Enter Command Mode for NODE (see below)

*5MACRO

Execute MACRO

*6

Autopatch Connect

*0

Autopatch Disconnect

*7

Node List (directly connected only)

*80

Force ID

*81

Get time of day

*82

Get software revision

*830

Parrot Mode Disable

*831

Parrot Mode Enable

*832

DTMF pad test. Dial command plus any digits except # then # as
the last digit to read back DTMF digits dialed including the terminating
# digit.

*85

Return the originating node number of and the number of seconds since the last keying/unkeying event. This works with all reachable nodes (i.e. it is global).

*87

Full Node List

*951NODE

Disconnect Permanent link to NODE

*952NODE

Connect Permanent Monitor-only link to NODE

*953NODE

Connect Permanent link to NODE

*954

All links off (including Permanent ones)

*969032

System Disable

*969031

System Enable

*969068

System Reset

*99

Send 1 KHz test tone

*97

Force (*) thru system

*90

Force (#) thru system